18
GENERAL ADVICE
Important:
Before any operation of cleaning and
maintenance disconnect the appli-
ance from the electrical supply.
It is advisable to clean when the
appliance is cold and especially for
cleaning the enamelled parts.
Avoid leaving alcaline or acidic sub-
stances (lemon juice, vinegar, etc.) on
the surfaces.
Avoid using cleaning products with a
chlorine or acidic base.
The oven must always be cleaned after
every use, using suitable products.
STAINLESS STEEL AND ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water only or
other non-abrasive products.
Dry preferably with a chamois leather.
Do not use a steam cleaner because
the moisture can get into the
appliance thus make it unsafe.
CLEANING AND MAINTENANCE
5
REPLACING THE OVEN LIGHT BULB
Switch the oven off at the mains.
Unscrew and replace the bulb with
another one resistant to high tempera-
tures (300°C), voltage 230 V (50 Hz), 15
W, E14.
NOTE: Oven bulb replacement is not
covered by your guarantee
INSIDE OF OVEN
This must be cleaned every time it is
used.
Remove and refit the side runner frames
as described on the next chapter.
With the oven warm, wipe the inside
walls with a cloth soaked in very hot
soapy water or another suitable product.
The side runner frames, tray and rack
can be removed and washed in the sink.
18
GENERAL ADVICE
Important:
Before any operation of cleaning and
maintenance disconnect the appli-
ance from the electrical supply.
It is advisable to clean when the
appliance is cold and especially for
cleaning the enamelled parts.
Avoid leaving alcaline or acidic sub-
stances (lemon juice, vinegar, etc.) on
the surfaces.
Avoid using cleaning products with a
chlorine or acidic base.
The oven must always be cleaned after
every use, using suitable products.
STAINLESS STEEL AND ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water only or
other non-abrasive products.
Dry preferably with a chamois leather.
Do not use a steam cleaner because
the moisture can get into the
appliance thus make it unsafe.
CLEANING AND MAINTENANCE
5
REPLACING THE OVEN LIGHT BULB
Switch the oven off at the mains.
Unscrew and replace the bulb with
another one resistant to high tempera-
tures (300°C), voltage 230 V (50 Hz), 15
W, E14.
NOTE: Oven bulb replacement is not
covered by your guarantee
INSIDE OF OVEN
This must be cleaned every time it is
used.
Remove and refit the side runner frames
as described on the next chapter.
With the oven warm, wipe the inside
walls with a cloth soaked in very hot
soapy water or another suitable product.
The side runner frames, tray and rack
can be removed and washed in the sink.
