PRESIDENT Richard, Руководство пользователя

Страница: 29 / 76

29
E) TECHNICAL CHARACTERISTICS
1) GENERAL
- Modulation modes : AM / FM
- Frequency range : from 28.000 to 29.700 MHz
- Antenna impedance : 50 ohms
- Power supply : 13.8 V
- Dimensions : 6.692 (W) x 6.299 (D) x 2.047 (H) inches
: 170 (W) x 160 (D) x 52 (H) mm
- Weight : 2.43 lbs / 1.1 kg
- Accessories supplied : 1 microphone electret UP/DOWN with
support, mounting cradle, screws and
fused power cord.
2) TRANSMISSION
- Frequency allowance : ± 300 Hz
- Carrier power : 13 W AM (± 50 W PEP) / 40 W FM
- Transmission interference : inferior to - 50 dBm
- Audio response : 300 Hz to 3 kHz AM/FM
- Emitted power in the adj. channel : inferior to 20 μW
- Microphone sensitivity : 3.0 mV
- Drain : 7 A max. (with modulation)
- Modulated signal distortion : 2 %
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad : 0.7 μV - 110 dBm (AM)
0.35 μV - 116 dBm (FM)
- Frequency response : 300 Hz to 3 kHz (AM/FM)
- Adjacent channel selectivity : 60 dB
- Maximum audio power : 3 W
- Squelch sensitivity : minimum 0.2 μV - 120 dBm
maximum 1 mV - 47 dBm
- Frequency image rejection rate : 60 dB
- Intermediate frequency rej. rate : 70 dB
- Drain : 500 mA maximum
F) TROUBLE SHOOTING
1) YOUR RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that the microphone is properly plugged in.
English
- Check that the
RF POWER
value is set on maximum. (See §
RF POWER
page
22) .
- Check that the
MIC GAIN
value is set on maximum. (See §
MIC GAIN
page
22) .
2) YOUR RADIO WILL NOT RECEIVE OR RECEPTION IS POOR
- Check that the squelch level is properly adjusted.
- Check that the volume (
1
) is set to a comfortable listening level.
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that you are using the same modulation mode as your correspond-
ent.
- Check that the RF GAIN level is set on maximum. (See § RF GAIN page
22) .
3) YOUR RADIO WILL NOT LIGHT UP
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
G) HOW TO TRANSMIT OR RECEIVE A MESSAGE ?
Now that you have read the manual, make sure that your transceiver is
ready for use (i.e. check that your antenna is connected).
Press the «push-to-talk» switch ( 17 ) and announce your message «Attention
stations, transmission testing» which will allow you to check the clearness
and the power of your signal. Release the switch and wait for a reply. You
should receive a reply like, «Strong and clear».
If you use a calling channel (19) and you have established communication
with someone, it is common practice to choose another available channel
so as not to block the calling channel.
H) GLOSSARY
INTERNATIONAL PHONETIC ALPHABET
A
Alpha
H
Hotel
O
Oscar
V
Victor
B
Bravo
I
India
P
Papa
W
Whiskey
C
Charlie
J
Juliett
Q
Quebec
X
X-ray
D
Delta
K
Kilo
R
Romeo
Y
Yankee
E
Echo
L
Lima
S
Sierra
Z
Zulu
F
Foxtrott
M
Mike
T
Tango
G
Golf
N
November
U
Uniform