PRESIDENT Richard, Руководство пользователя

Страница: 24 / 76

24
11) PRIORITY CHANNELS
Priority channels will be automatically
selected
by switching this key (
11
).
3 positions switch:
EMG1
/ Priority channel 1 is activated.
EMG2
/ Priority
channel 2 is activated.
OFF /
No priority channel is activated.
The default priority channels are channel 9/AM/band A ( EMG1 ) and chan-
nel 19/AM/band A ( EMG2 ).
See the EMG SET 1 and EMG SET 2 menus page 26 to set priority channels.
Note:
Activating a priority channel no longer allows you to change modula-
tion mode (AM or FM), to start the
SCAN
function or activate the
PA
mode.
If the
KEY BEEP
function is active, an error beep is emitted.
“EMG”
and the
channel blink to indicate unauthorized handling. Turn the switch (
11
) to the
OFF
position to use these functions.
12) ECHO
Allows to enable / disable ECHO function.
See menu
ECHO SET
page 28 for
ECHO
configuration.
13) MODE ~ PA
MODE
(short press)
Press
MODE
key (
13
) to
select
the modulation mode: AM or FM. Selected
mode is displayed on display.
Your modulation mode has to correspond to the one of your correspondent.
- Frequency Modulation / FM : for nearby communications on a flat open
field.
- Amplitude Modulation /
AM
: communication on a field with relief and
obstacles at middle distance (the most used).
PA
(long press)
Switch between normal and
PA
(Public Address) mode.
An external optional speaker can be connected to the unit to the PA.SP.
jack on the rear panel. (
D
). Turn the
MIC GAIN
knob (
4
) to adjust the
PA
volume.
For details on operating in
PA
mode, see the PA SETTING menu on page
27.
14) BARGRAPH
Indicates the reception level and the emitted power level.
15) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the
setting of the equipment into the dashboard easier.
See Cabling Diagram page 74.
16) USB CHARGING SOCKET
The USB socket ( 16 ) can be used to charge smartphones, tablets or other
rechargeable devices with 5 V - 2.1 A.
17) PTT
Transmission key, press to
transmit
a message, is displayed and release
to listen to an incoming communication, disappears.
TOT (Time Out Timer)
If the PTT switch ( 17 ) key is pressed for more than 5 minutes, the display starts
blinking and the transmission ends . A beep will sound until the PTT switch
( 17 ) key is released.
18) UP/DN BUTTONS ON MICROPHONE ~ SCAN
UP/DN BUTTONS ON MICROPHONE
(short press)
In normal use, press
UP
/
DN
buttons (
18
) on the microphone to
change
the
frequency.
UP
to
increase
and
DN
to
decrease
the frequency.
In MENU mode [press the PUSH knob ( 6 ) for about 3 seconds to activate this
mode (see § MENU page 25) ], the UP or DN buttons ( 18 ) allow to select
the menu to be set.
See ROTARY “PUSH” KNOB page 22 .
English