PrepPal PPM 60, Руководство пользователя

Страница: 8 / 14

8
CRAWL for speed handle switch
Setting Timer
Use the Attachment Hub
Timed Operation: Press the red button to the TIMER side. To set the
time for the appropriate mixing time, turn the timer knob in a
clockwise direction at the position between
“
0
”
to
“
30
”
, to get
mixing time between 0 mins to 30mins.

Non‐Timed Operation: Press the red button to the NON‐TIME side
to set the mixer for non‐timed operation.
NOTE: Heavy loads should not be mixed longer than fifteen (15) minutes
at this setting without an equal amount of rest time for the mixer. failure
to adhere to these instructions may cause the mixer to automatically shut
off due to overloading.

Never put your hand into the feed chute when using a mixer attachment.

Only operate the attachment hub in MANUAL mode.

DO NOT attempt to mix ingredients in bowl while using the hub.

Mixer must be OFF before installing attachment.

Do NOT use attachments while mixing.
1. Loosen and remove attachment hub fasten screw. Then Remove hub cover.
2. Lubricate attachment shaft with a food quality grease or mineral oil.
3. Insert attachment shaft into hub making sure to line up the alignment pin
with hub hole.
4. Tighten thumbscrew back into hub and securely tighten it.
5.Select the appropriate speed setting by lifting or lowering speed control
lever.
6. Use the untimed operation described on the previous page to adjust timer.
7.Press the green START button located on the control panel.
Recommended Speed while using attachments:
Attachment: Recommended Speed:
Meat Grinder
1 only
NOTE: Make sure bowl is up and bowl guard is closed. Mixer will not start if
bowl and bowl guard are not in the proper operating position.
If it is difficult to switch the speed handle at right position, you can press
the button of (LAMP&CRAWL) transitorily.
Press the button of (LAMP&CRAWL) transitorily can let the planetary
shaft rotate by a little angle, so gears can occlude.
Can press the button of (LAMP&CRAWL) transitorily for several times
until the speed handle can be switch to right position.