Premier ED-5189PRO, Инструкция по эксплуатации

Страница: 8 / 23

HOW TO USE
6
Icon Function Procedure Display Lighting
Rinse
Speed H for 5s, stop for 2s.
Run the cycle 4 times. Preset display is 28s and
Speed H. All soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Puree
Speed H for 3s, stop for 3s. Run the cycle 10
times. Then run in Speed H for 40s. Preset
display is 1m 40s and Speed H. All soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Soup
Increase from Speed 1 to Speed 7 in 5s. Then
increase to Speed H in 5s. Keep in Speed H until
8min. Preset display is 8min and Speed 1. All
soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Manual
This button flashes when the product starts up.
Preset display is 30s and Speed 3. All soft start. Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Smoothie
Speed H for 8s, stop for 2s. Run the cycle 5
times. Preset display is 50s and Speed H. All
soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Crush
Hard start in Speed H for 2s, stop for 4s. Run
the cycle 10 times. Preset display is 1min and
Speed H. All soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
Frozen
Speed H for 4s, stop for 2s. Run the cycle 10
times. Preset display is 1min and Speed H. All
soft start.
Time & Speed
LED flashes in 0.5s
ON / 0.5s OFF cycles
• START/STOP(ON/OFF) Button
• This button is to start the operation. After a function is selected, the product will
only operate after pressing the button. Press again to stop operation. In
Ready Mode and Standby Mode, this button flashes red light. It display green light
in operation.
• Manual Button
After pressing this button, the Speed Setting / and Time Setting
/ can be adjusted. Both settings can also be adjusted during operation.
In this mode, the Manual Button flashes white light.
• Pulse Button
This is Pulse Button, and it can only operate when the button is kept pressing. The
motor runs in full speed (i.e. Speed H) with a soft start. This button has no time limit
and overrides the program functions. That means when the Pulse Button is pressed
on hold, the product directly enter the Speed H. The product resumes Ready Mode
upon the release of this button. This button keeps light on white light.
• Program Buttons , , , , & , total 6 programs. The descriptions of each
program are mentioned below :
• Use Selection Dial to select the desired program, the corresponding icon will flash.
Then press the “ ” Button to run the selected program, and the “ ” Button
lights on green LED. Press the “ ” again during operation will stop the program.
The product resumes Ready Mode.
• If the Time / Speed Setting is adjusted during operation in any preset program. The
product will switch to mode, and short-cut button light will change to Button.