Premier ED-5189PRO, Инструкция по эксплуатации

Страница: 10 / 23

CLEANING & STORAGE
• Unplug the appliance from the wall outlet.
• Do not immerse the motor unit or power cord into water or other liquids.
• Clean surface of the blender jar with soft cloth or spongy. The measuring cup and
the seal ring can be disassembled for cleaning.
• The blender jar can be rinsed with water. It can also be cleaned by filling 2 cups of
water in the blender jar, close the lid and then operate the blender in Pulse mode.
Then pour out the water and dry it with soft cloth.
• After cleaning, put the blender jar on the side or upside down (Note 1) to dry. Do not
immerse the whole jar in water.
• Clean the motor unit by soft cloth. NEVER put it in water.
Note 1 : If put the blender jar in upside down position, please remove the residual
water by dry cloth. Do not leave it close to the sink or basin to avoid water
spraying to the bottom part of the jar. This may cause the rusting of the
bearing and hence affecting the performance of the blender.
• If the motor is dragged to a low speed since the food is too thick or there is too less
liquid in the jar, and operates for a proloned period, the temperature monitoring
system will trigger and stop the operation of the motor. In this case, unplug and put
the blender to a place with good ventilation to cool down the motor temperature for
45 minutes. The system will reset and the blender can be used again.
• During operation, close the lid tightly to avoid scalding due to spraying of hot liquids.
• Keep hands and utensils out of the container while the motor is running to prevent
the possibility of severe personal injury and/or damage.
• In making hot beverage such as soybean milk, hot soup, please check whether the
lid is secured tightly to the jar to prevent it from falling. It is advisable to start the
operation at low speed setting and increase the speed gradually, or use the Pulse
Drive mode.
• When making sauces (eg. Almond sauce, jam and sesame sauce), stuffing and
nuts,put in between 2 and 3 cups of ingredients. The amount should neither be too
large or too little. Keep the blending time below 2 min. to prevent any burnt smell
due to overheating. Too much ingredients may lead to overlaoding and overheating
of the motor. In this case, wait till the motor temperature fall before operating again.
• Please put liquid and soft food before putting in hard food or ice cubes.
• When the operation finishes, please wait until the blade assembly comes to a
complete stop before taking up the blender jar. Otherwise, the Drive Gear may be
damaged.
NOTICE FOR OPERATION
8
LID, MEASURING CUP, SEAL RING
• Insert the measuring cup to the lid by aligning the two taps to the grooves of the lid
and twist to lock it at the bottom position. Then push in the lid to the blender jar to
close it. To open, pull up the flap of the lid.
• The seal ring is detachable from the lid for easy cleaning.