Page 15
Installation Instructions
LPSA3747
Tension Adjustment
The mount shown in this illustration is upside down
to demonstrate how to access the adjustment nuts.
This unit comes pre-tensioned at the factory. To adjust the
swingout arm, perform the following steps:
Adjustment Nuts
Plastic End Caps
Top
Bottom
Step 1.
Remove the plastic end caps.
Step 2.
Take a socket (supplied) and ratchet and tighten/loosen
the nut to the desired tension.
Step 3.
Replace the plastic end caps.
Cable Management
LPSA3747
Cable Tie
Cable
Flat Panel
Step 1.
Route all cables along the LPSA3747.
Step 2.
Use a cable tie to attach the cable to the LPSA3747 (as shown above).
Step 3.
Cut off excess cable tie.
Before routing the cables and attaching the tie wraps, the LPSA3747 must be fully extended away from the wall.
Cable Access Ports
The cable access ports may be accessed by removing the plastic caps. The cable access ports allow you to route your
cables through the base of the LPSA3747 and into the wall.
