Installation
Instructions
Page
14
LPSA3747
M4 x 10mm Phillips Head Screws
Step 2
. Insert the head of the screws through
the keyhole slots on the adapter plate.
Step 3
. Insert and tighten the bottom two (2)
M4 x 10 Phillip screws to secure the
adapter plate to the mount.
Step 4
. Use a Phillips tip screwdriver to
tighten all mounting hardware.
Do not over-tighten the mounting
screws.
LPSA3747 Installation with Adapter Plate
Step 1.
The cover plate of the LPSA3747 must be
mounted to the wall plate that is attached to the
wall.
Step 2.
The wall plate receptacle must be placed over
the top of the wall plate, so that the entire mount
“hangs” on the wall plate.
Step 3.
Use the M3 Allen wrench (supplied) to tighten
the locking screw that is located on the bottom of
the mount base.
This locking screw will prevent the mount and flat panel
from being lifted off of the wall plate.
Failure to fully tighten the locking screw may
result in possible damage to your flat panel.
Locking Screw
M3 Allen
Wrench
