1) Place the Mount against the wall and align it with the pilot hole.
2) Insert one (1) 5/16"x 3˝ Hex lag and one (1) 5/16" washer into the
upper right pilot hole.
3) Use a socket wrench and a 1/2" socket to tighten the hex lag.
Do not overtighten the hex lag.
1) Level the wall plate.
2) Use a pencil to mark the remaining three (3) mounting locations
along the center of each wall stud.
Two people are recommended for this step; one person to level
the wall plate and another person to drill the pilot holes.
Drill a “pilot hole” in the center of each of the marks with a
power drill and a 1/4" drill bit.
Only use 1/4" drill bit when drilling the pilot holes.
1) Insert one (1) 5/16" x 3" Hex Lag and one (1) 5/16" washer into each pilot
hole
2) Tighten all hex lags using a socket wrench and 1/2" socket.
Do not overtighten the hex lag when attaching the mount to the wall.
Improper installation may result in personal injury or property damage.
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
AM300-B
Page 6
4
5
6
7
