Route power and data cables through any of the access
points on the Swingout Arm. This not only helps to
prevent cables from being pinched, but helps hide
unsightly cable clutter.
Before making any tilt adjustments, loosen both tension bolts nut one-half turn.
After making any tilt adjustments, tighten then tension bolt nuts one-half turn.
Adjusting the Tilt Angle
1) Place one hand at the center top edge of the flat panel.
2) Place the other hand on the center bottom edge of the flat panel.
3) Using the upper hand, gently pull the top of the flat panel towards while
the lower hand gently pushes the bottom of the flat panel away.
Adjusting the Flat Panel to the Original Position
1) Place one hand at the center top edge of the flat panel.
2) Place the other hand on the center bottom edge of the flat panel.
3) Using the upper hand, gently push the top of the flat panel towards the wall
While the lower hand gently pulls the bottom of the flat panel away from the wall.
Tilting Positioning
Cable Management
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
AM300-B
Page 14
24
25
