3.4 COOLING FUNCTION
3.5 SLEEPING FUNCTION
3.6 HEATING FUNCTION
3.7 DEHUMIDIFING FUNCTION
3.8 FAN FUNCTION
3.9 AUTO MODE
3.10 TIMER FUNCTION
AUTOMATIC SWITCHING OFF
- Press the MODE button until the cooling mode is set.
- Press the
and
buttons to set the required room temperature.
- Press the
button and select the fan speed to high
,middle
, low
or auto.
(If AUTO is chosen, the fan speed is automatically adjusted to keep it as high as needed to reach the set
temperature) .
- Press the MODE button to find cooling
/heating
/auto
.
- Press the
and
buttons to set the required room temperature (not possible in AUTO function).
- Press the
button : when this icon is displayed, the fan speed is automatically set at the lowest level.
- Press again
to cancel this function setting.
- Press the MODE button until the heating mode is set
.
- Press the
and
buttons to set the required room temperature.
- Press the
button and select the fan speed to high
,middle
, low
or auto.
(If AUTO is chosen, the fan speed is automatically adjusted to keep it as high as needed to reach the setting
temperature).
- Press the MODE button until the dehumidifying mode is set
.
- The fan speed is automatically set.
- Press the MODE button until the fan mode is set.
- Press the
button and select the fan speed to high
, middle
,low
or auto.
- Press the MODE button until the AUTO mode is set.
- Press the MODE button and set the desired function.
- Press the buttons
and
to set the required room temperature.
- Press the
button and select the fan speed among high
middle
,low
or auto.
(In case AUTO is chosen, the fan speed is automatically adjusted to keep it as high as needed to reach the
setting temperature).
- Press the
button and adjust the switching off time pressing the button
(hours) and
(minutes).
- To confirm the setting, press again
.
- Once the time is over, the unit will switch off automatically.
The setting will be cancelled if the button
is pressed again.
When you set the temperature in cooling mode, the LCD on the front of the unit shows the set point, then
after a few second the LCD display will then revert to room temperature and will decrease by 1 degree C in
turn until the unit reaches your desired temperature.
When the equipment first turns onto heating mode, there will be a short delay of three or so minutes, this is a
normal time delay function and the equipment will start heating after this short period of time.
When you set the temperature in heating mode, the LCD on the front of the unit shows the set point, then
after a few second the LCD will then revert to room temperature and will rise by 1 degree C in turn until the
unit reaches your desired temperature.
In this mode the air conditioner will attempt to maintain the room temperature between 20 C and 25 C.
If the room temperature is below 20 C it will be in heating mode, if it rises above 25 C the unit will be in
cooling mode, if it is between the two the air conditioner will simply circulate room temperature air.
The reason for the 5 C 'gap' is to stop the compressor oscillating rapidly between heating and cooling as this
would severely shorten the life of the product should it be allowed to happen.
o
o
o
o
o
14
