24
CHANGING HYDRAULIC OIL FILTERS.
There are two hydraulic filters on this machine. One suction (90 micron) located within the
main tank and a 25 micron return filter located in a housing on top of the hydraulic tank.
The hydraulic oil filters must be changed on a yearly basis regardless of use or 10 hours
after any kind of servicing to the hydraulic system.
OIL CHANGING - See engine manual
Undo oil drain plug located on the end of a hose
at point (9)
Drain oil into large container.
Replace oil drain plug and tighten.
Refill through point (6).
Use the dipstick (7)to check level.
Do not overfill.
CHANGING ENGINE OIL FILTER - See engine
manual.
After draining oil, undo filter near battery
Replace filter with new and tighten.
Refill with oil to level on dip stick.
CHANGING HYDRAULIC OIL
The hydraulic tank (14)
Place a clean dry container under the drain
plug (11) and loosen until hydraulic fluid
starts to drain into the container. The
container should be capable of holding
approximately 40 litres.
Thoroughly clean area around the filter cap
(15) before unscrewing to avoid oil
contamination.
When fluid has stopped draining remove filter
from housing (15) and replace with new.
Replace cap.
Re-tighten plug and refill hydraulic system via
filler cap (15) to the middle of the level gau
e.
10. Fuel tank
11. Drain plugs
12. Battery
13. Oil filter
14. Hydraulic tank
15. Return filter
