18
4. Cutter switch with safety cover
5. Micro speed selection switch
6. Green LED
7. Emergency stop
8. Red LED
9. On/Signal/Freq shift Sync
10. DANGER
11. Arm lift / lower lever
12. Left track forward / back
14. Variable width
15. Right track forward / back
16. Slew left right
Levers (11, 12, 14, 15, 16) are all proportional and operate in the same way as described earlier in
the manual.
Radio Control (option)
Unauthorized tampering with the radio control system automatically invalidates warranty
The radio control unit is highly sophisticated and offers fine control to the movements of the machine.
Fine tuning of the controls can be made only by a qualified technician or under his instruction.
The manoeuvre levers give fully proportional operation and are sprung loaded to return to zero posi-
tion, i.e. "dead-man's-handle". When the manoeuvre levers are moved from zero position the respec-
tive hydraulic function starts to operate slowly and increases in speed as the lever is moved further
from zero position and vice versa as the lever is moved back towards zero position.
For safety reasons all manoeuvre levers must be in their zero/neutral positions for a start-up to be
made. If any lever is not in its zero/neutral position during start-up, the control unit will blink and beep
the same number of times as the number of the lever to indicate which manoeuvre lever is faulty. The
control unit can be used but the faulty lever will be locked and disengaged. (eg. if it beeps and blinks
five times, it is the 5th lever from the LEFT which is faulty or giving the problem signal).
The micro speed button (5) slows down all the movements. This return sprung switch can be used to
reduce the operating speed.
With impulses from the sprung loaded toggle switch to the left,
towards ON ( tortoise)
, reduces
speed. Movement of the switch to the right,
towards OFF (hare)
, will produce 100% movement once
again. Green LED : Flashing - speed reduction. Not flashing - normal speed .
The large red emergency stop button (7) turns off the radio control unit when pushed in. It also stops
the cutter wheel. IT DOES NOT STOP THE ENGINE ON THE MACHINE.
The main emergency stop
switch is located on the machine.
Twist the switch (7) clockwise until it springs out, then push the On
button (9) to turn the unit on. The red LED light (8)will show that the unit is on.
Switch (4) is the cutter selection switch. This
must be in the off position to start the machine.
