1. Access the Hardware Validation service menu (51765761) and perform the fol-
lowing tests, see
"Standard Service Menus" on page 36
.
Select
Test
to start the test and
Stop Test
to exit.
l
Display GUI/Metric Tests
o
Backlight brightness changes.
o
Numerals cycle properly.
l
Key Test
o
Keys all function.
l
Heart Rate Test
o
Heart rate is acquired and displayed.
l
Belt Speed Test
o
Running belt moves and is controlled from 0.5 mph to 12.0 mph in
0.1 increments.
l
Incline Test
o
Use the incline controls to raise/lower incline to verify the following
incline angle
A/D
1
values:
n
Nominal A/D value: 13 ±5 @ -2% incline.
n
NominalA/D value: 37 ±5 @0% incline.
n
Nominal A/D value: 242 ±5 @ 15% incline.
2. Exit the Hardware Validation Diagnostic Test menu (press the
Home
softkey).
Machine Operation Test
This test verifies the console functionality (motion controls & metric indicators) and
machine operation.
SPEED control test
:
1. Do this test while walking on the machine and the INCLINE set to 0% incline.
2. Select
QUICKSTART
to begin a manual workout.
3. Operate the
SPEED
motion control from minimum to maximum range while veri-
fying the machine operation.
l
Make sure that the console SPEED paddle control operation is smooth
and working correctly.
l
Verify that the running belt can reach the maximum speed and then
returns to the minimum speed level.
l
Make sure that the running belt speed change is smooth and that there are
1
analog to digital converter
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 18
3 Operation Verification
R40 Operation Verification Test
