ProtEX-MAX PD8-6310-WM Explosion-Proof NTEP Certified Batch Controller Instruction Manual
50
Advanced Operation and Programming
In addition to the functions described in Controller Operation on page 26, the following advanced
operation and display features may be programmed. Configuring these features may disable some
default batch controller features, or make running a batch operation impossible. These functions should
only be used by users who are sure of their need in their application.
Advanced Features Menu
To simplify the setup process, functions not needed for most applications are located in the
Advanced
Features
menu.
Press and hold the Menu button for three seconds to access the advanced features of the controller. This
cannot be done during a back process as all functions other than STOP are disabled during a batch
process, including the Menu button.
Advanced Features Menu & Display Messages
The following table shows the functions and messages of the
Advanced Features
menu in the order they
appear in the menu.
Display
Parameter
Action/Setting
Gate
Gate
Gate settings
Lo G
Low gate
Program Low gate value
Hi G
High gate
Program High gate value
filter
Filter
Set noise filter value
Hi spd
High Speed
Filter
Program High Speed
Filter
Lo spd
Low Speed
Filter
Program Low Speed
Filter
Round
Round
Set the rounding value
for display variables
seriAl
Serial
Set serial
communication
parameters
SlaveId
Slave ID
Set slave ID or controller
address
baud
Baud rate
Select baud rate
Tr dLY
Transmit
delay
Set transmit delay for
serial communication
Display
Parameter
Action/Setting
Parity
Parity
Select parity
Even, Odd, or None with
1 or 2 stop bits
t-byt
Time byte
Set byte-to-byte timeout
SelEct
Select
Enter the Select menu
(function, cutoff, out)
Functn
Signal Input
Conditioning
Select linear, square
root, or programmable
exponent
Linear
Linear
Set controller for linear
function and select
number of linearization
points
CutofF
Cutoff
Set low-flow cutoff
Count
Count
Set the totals to count up
or down from a set value
Tot C
Total count
Set the batch to count up
to or down from the
preset
