Prebena 3X-CNW50, Руководство оператора

Страница: 83 / 315

After operation
33
WARNING
Danger of injury due to recoil
and accidental triggering.

Press the fastener driving tool firmly
against the wood.

Place the tip of the fastener driving tool on the piece of wood
and press the fastener driving tool briefly against the piece of wood.
The nail is driven in.

To drive in additional nails, continue holding down the triggering
mechanism.

Place the fastener driving tool at the next desired position.

Press the fastener driving tool against the piece of wood.
The next nail is driven in.
You can repeat this process as long as you hold the triggering
mechanism depressed and there are nails in the magazine.
After operation
After operation or extended interruptions in operation, carry out the steps
described below.
Disconnecting the compressed air supply

Turn off the compressor.

Pull the quick lock on the compressed air hose away from the handle.
The quick lock is now unlocked.

Pull the compressed air hose off the connection on the fastener
driving tool.
The compressed air in the fastener driving tool can be heard
as it escapes.
Emptying the magazine

Open the magazine as described on page 19.

Remove the coil.

Make certain there is no wire residue in the magazine.

Remove any wire residue that is present if necessary.

Close the magazine as described on page 24.