Prebena 11-WP130, Инструкция по эксплуатации, Страница: 46 / 59

Page 18 of 30
Malfunctions
WARNING
Operating a damaged or malfunctioning stapler can result in serious or
fatal injury.
➢
In the event of a malfunction, immediately disconnect the stapler
from the compressed air supply.
➢
Remove the magazine and all staples from the feed channel and
on feed bridge.
➢
Do not use the stapler until the malfunction has been remedied.
Important
The stapler can be damaged by repairs undertaken by unauthorised persons.
➢
Make sure that the stapler is only repaired by the manufacturer.
Malfunction overview
Possible malfunctions and the necessary measures are listed in the overview below.
Symptom Possible cause Remedy
Stapler is losing
air. Fastening screws have
become loose. Notify customer service.
A seal is defective. Notify customer service.
Operating
pressure too high. Valve defective. Immediately disconnect the stapler from
the compressed air supply.
Notify customer service.
Operating pressure set too
high or stapler damaged. Reduce operating pressure.
If the problem persists:
Immediately disconnect the stapler from
the compressed air hose.
Notify customer service.
Staples are not
being fully driven
in. The operating pressure is too
low.
Increase operating pressure.
The driver tip on the stapler is
worn/broken. Notify customer service.
Staples cannot be
discharged. The operating pressure is too
low. Increase the operating pressure of the
compressed air system to the maximum
permissible level.
The moving parts are stuck
together with lubricant after
long storage. Clean stapler.
Set maximum operating pressure.
Perform test discharges.
When discharging, set the required
operating pressure.
Otherwise notify customer service.
Discharge is
triggered without Feed bridge/channel is soiled. Clean feed bridge/channel.
Incorrect staples have been
loaded.
Remove staples.
Fill stapler with PREBENA staples.