PPI SOFTIE 180 Back, Инструкция по эксплуатации и упаковке

Страница: 45 / 47

43
Owners Manual - Revision 1.5
4.14.2. Compress the Pilot chute between the rubber
bumpers; being sure the Pilot chute canopy fabric is
tucked into the coils of the spring. Thread the pull-up
cords up through the grommets in the grommet strap.
Removing one temporary pin at a time, Pull up the
closing loops and secure the Pilot chute in place with the
two temporary pins. Figure 4.14.2
4.14.3. Take this opportunity to check canopy distribu-
tion and simulate how the corners of the container will
fill out once the container is completely closed. Make
any necessary adjustments at this time. Figure 4.14.3.
4.14.3 Place the pad on the back of the container and
attach the snaps at the rear corners of the container first.
4.14.4. Roll the number one fold up and in on the right
side. Repeat with the number three fold. Figure 4.14.4.
Note:
When rolling the folds into position, use the edge of the
container as a guide. The canopy fabric will naturally
expand outward to fill the corners of the container.
4.14. 5.Repeat section 4.14.4 on the left side of the
container with fold numbers two (2) and four (4).
4.14.6. Close the right side flap using the same tempo-
rary pin removal instructions as in section 4.14.2. Fig-
ure 4.14.6.
4.14.7. Close the left side flap removing one temporary
pin at a time and installing the ripcord pins. Seal the
upper pin in the accepted manner.
4.14.8. Using the Checklist, sections 4.1.1 and 4.1.5, be
sure you have removed all tools from the container
system.
4.14.9. Fill in the appropriate information on the packing
data card and your log book and install packing data
card in the packing data card pocket.
Figure 4.14.2
Figure 4.14.3
Figure 4.14.4
Figure 4.14.6