PPI SOFTIE 180 Back, Инструкция по эксплуатации и упаковке

Страница: 35 / 47

33
Owners Manual - Revision 1.5
Figure 4.8.3
Figure 4.8.11
4.8.3. Move the skirt of the canopy to a lower corner of the Con-
tainer.
4.8.4. lay the diaper so that the top side (line stows) are face up in
the container.
4.8.5. At the same time turn the canopy 90 degrees so that the radial
seams are parallel to the bottom edge of the container. Figure 4.8.3.
4.8.6. Make three (3) “S”-folds back and forth across the container
below the closing loop. Make each of these folds just outside (about
two (2) inches) the edge of the container. This will provide adequate
bulk in the lower portion of the container. Figure 4.8.3.
4.8.7. Lay the lower pull -up cord over the canopy folds toward
the bottom end of the container. Figure 4.8.7.
4.8.8. Make two (2) more “S”-folds across the container between
the two (2) ends of the closing loop. Make these folds slightly
shorter than the folds below the bottom loop but, still just outside
the container (about one (1) inch). Figure 4.8.7.
4.8.9. Lay the upper pull -up cord over the canopy folds toward
the bottom end of the container. Figure 4.8.7.
4.8.10. Continue “S”-folding the remainder of the canopy to fill
the upper portion of the container. These folds should be right at
the edge of the container. Figure 4.8.7.
4.8.11. Make last fold back toward the middle of the container.
Figure 4.8.11.
4.8.12. Lay the Pilot chute and bridle toward the lower end of the
container. Figure 4.8.11.
Figure 4.8.7