Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
6)
Remove the horizontal square tubes from the bottom of the center section, lay the rest of the
center section on the flat surface, use blocks screwed down to hold in place, make sure all
joints are tight and all chromoly inserts are in place
7)
Drill ¼ inch holes ½ inch in from each side of joints in square tubing. Lift the assembly out and
use AN4-14A bolts to bolt together (1 bolt, 2 washers & 1 nut per hole) Leave the bottom
square tubes off yet.
