Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
J Bars & Harness
For Paracruiser, Aerothrust, Blackhawk, Miniplane and Fantom harnesses.
Flatten the end of the J bar closest to the harness in a vise. Flatten this end 90 degrees to the
small hole. It does not need to be closed tight, only about halfway closed. File all sharp edges nice
and round, this flat end will slide into the pocket on the harness webbing, you want no sharp
edges there.
For locating the position of the hole, it is best to have your harness and slide the J bar into the
pocket and mark your holes location. Drill a 7/32” hole, use a 10-32 flathead bolt through the
grommet on the harness and through the J bar, with a nylock nut on the backside. Cut off and
bolt protruding past the nut and file smooth.
