Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
Final Assembly
1)
Remove the hoop and radial tubes from the center section. Re-install the bottom horizontal
square tubes to the bottom of the vertical square tubes. Slide the 21 inch chromoly bottom
hoop section through the holes at back of the bottom square tubes, roughly centered. Slide
the square diagonal brace tubes onto the 21 inch chromoly tube tight to the bottom square
tubes. Install the two AN4-24A bolts through the vertical tubes and the diagonal brace tubes
with a large area washer on each side.
2)
Check that everything on the lower section is square and the 21 inch chromoly tube is
centered and drill and bolt the connections at the bottom of the vertical square tubes. Also
bolt the 21 inch chromoly tube to the bottom horizontal square tubes. Use AN4-14A bolts to
bolt together (1 bolt, 2 washers & 1 nut per hole)
Note:
You can also bolt the diagonal brace tubes to the 21 inch chromoly tube but it is not
necessary as the lower hoop tubes will trap them in place.
