Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
all the way to the connector anchors. Now you can form the top 0.625 hoop tube, be sure it
slides into the 0.750 tube all the way to the anchor, insert a pencil or nail into the other 0.750
tube and determine where the end of the anchor is and mark it on the outside of the tube. Mark
and cut off the 0.625 upper tube to length.
Once again being sure the lower part of the center section is in place above the layout surface.
Also being sure all joints at both ends of radial tubes are tight, you can now drill the ¼ inch holes
½ inch from the ends of the radial tubes, all the way through for double button clips, do your
best to drill these straight and centered, the clips will work better. Insert the clips.
Finished radial tube and hoop joints
