Powrmatic PHS 25, Инструкция по установке и эксплуатации

Страница: 26 / 52

Form #44201150
Sept 2010 -25-
Table 11
U-Model
Heaters
Linear Model
Heaters
MODEL Turbulator Sections Burner Leg Fan Leg Fan End
PTSL 25 65mm x 572mm - - 4
PTUL 25 65mm x 572mm 2 - -
PTSL 30 90mm x 610mm - - 9
PTUL 30
90mm x 610mm
3 5 -
PTSL 35
90mm x 610mm
- - 5
PTUL 35
90mm x 610mm
3 2 -
PTSL 40
90mm x 610mm
- - 3
PTUL 40 90mm x 610mm 1 - -
PTSL 45 90mm x 610mm - - -
PTUL 45 90mm x 610mm - - -
10.3) ATTACHING U-BEND
U-Bend (76.2mm Tubes)
1. Assemble the U-Bend to the tubes with the two (2) threaded holes facing downwards, ensuring that the tubes
engage fully.
2. Using two (2) 5/16” BSW hexagon socket setscrews (from fastening pack) secure the U-Bend to the radiant
tubes.
IMPORTANT: Failure to assemble the radiant tubes with their welded seam facing away from the reflector will
void the manufactures warranty.
U-Bend (101.6mm Tubes)
1. Assemble the U-Bend to the tubes, ensuring that the tubes engage fully.
2. Drill one
Ø 5.5mm
hole through the U-Bend and radiant tube in the lower surface of each leg at a distance
midway along the swaged portion of the U-Bend.
3. Rivet the U-Bend to the radiant tubes using the two
Ø 5 x 10 rivets provided (from fastening pack).
IMPORTANT: Failure to assemble the radiant tubes with their welded seam facing away from the reflector will
void the manufactures warranty.
PTUL 25 U-Bend Attachment (76.2mm tubes) PTUL 30/35/40/45 U-Bend Attachment
(101.6mm tubes)
5/16” BSW Hexagon
Socket Setscrews
Note: Welded seam of
tube must be positioned
on bottom side.
Note: Welded seam of
tube must be positioned
on bottom side.
Drill through - Ø 5.5mm.
Secure using Ø 5 x 10 rivets.
Bottom View
Bottom View
Fig. 25