Powerware Plus 80, Операция

Страница: 71 / 160

Remote Monitor Mode
I
I
I
I
I
I
I
I
I
I
I
I
I
Remote Monitor mode you to connect a port to a Remote Monitor Panel (RMP) or a
Relay Interface module (RIM). This mode provides the communications settings required
for the RMP or RIM to communicate
the UPS In Remote Monitor mode, the baud rate
must always be set to 300 baud. You can install up to two remote accessories or
to monitor the operation of the UPS system from virtually any location within your
facility, up to feet from the UPS.
The RMP contains a local and these backlit status indicators:
SYSTEM NORMAL
NOREDUNDANCY
ON GENERATOR
ON BYPASS
UPS
ON
BYPASS UNAVAILABLE
SHUTDOWN IMMINENT
The relay interface module (RIM) uses relay contact closures to indicate the operating
status and alarm condition of me UPS system. The RIM can provide these signals:
UPS AVAILABLE (connector pins 1 and 12)
UPS OFF LINE (connector 3 and 13)
FAILURE (connector pine 6 and 16)
WEAK (connector pine 5 end 14)
For
more
information about the RMP and RIM indicators, see
For information about installing an RMP or an RIM. see
1 2
Power-ware Plus UPS Communication