2 battery cabinets to the UPS:
Remove the right top deadfront and the left top deadfront. Save them and their
hardware for later reuse.
Note:
If you are installing more than
one
battery cabinet, perform this step only
for the last battery cabinet on either end of the line up (only one end will be
wired to the UPS).
Install the lug kii removed in step 3 of “To prepare battery cabinets” on page
Note: If you are using a wall-mounted battery disconnect (optional), see
G on page
to
the wiring needed between the battery cabinets and
the UPS. Then skip to step below.
Connect one cable to each of the two battery breaker terminal lugs indicated in
Figure 22. (See Table on page A-6 for lug sizes.) Route both cables to
terminals E4 and
of the UPS in either of these ways:
l
Through the top entry location
in Drawing
on
page A- 16)
l
Through
the bottom
entry
location (see Drawing
for the
bottom entry routing hole location)
4. See Figure 3 on page 11 to locate
in the UPS cabinet. If
is supplied,
connect two control wires to and route the wires through the battery cabinet
top or bottom entry to
See Table L on page A-2 for wiring
Replace the deadfronts you removed in step 1 of this procedure.
6.
After making sure that the battery breaker (see Figure 22 on page 36 for
location) is in the
OFF position, connect the battery
strings
in the battery cabinet
by mating
disconnected battery drawer connectors to the closest string
connectors.
Mount the right side panel (removed in step 1
of
prepare the battery
cabinet”) to the right side of the end battery cabinet:
Mount
hanger bracket to the top right side of the battery
b.
Hang the
side panel on the hanger bracket and align it with the
front and rear
of
the battery cabinet
C.
the
side panel at the bottom.
6.
Secure all battery cabinets by reversing steps 1 3 of
prepare battery
cabinets” on page 36.
Secure the UPS by reversing the applicable steps performed in preparing the
UPS for installation of the battery cabinets (see page
Powerware Plus UPS
Manual
37
Содержание Plus 80
