Powerware Plus 80, Операция

Страница: 137 / 160

4. The UPS system, each battery cabinet, the cabinet. and the input
transformer cabinet are crated separately for shipping and are bolted together
on site.
not tilt cabinets more than during handling.
6.
Dimensions are in millimeters (inches).
7. If perforated floor tiles are required ventilation. should place them in front
of the UPS. Table lists the ventilation requirements for full load operation:
Table M.
Air Conditioning or Ventilation
Requirements During Full Load Operation
Ratings
Rejection
(Kg-cailhr)
8.
Recommended minimum clearance over the UPS module is 304.8 mm (12 in.).
Required for cooling exhaust: approximately 814.0 cfm).
Battery voltage is computed at 2 volts per cell as defined by 480 of the
NEC. Rated battery current is computed at 1.8 per cell.
10.
used between the battery and the UPS should not allow a
voltage drop of more than 1% of nominal DC voltage at rated battery current
11.
A battery disconnect is recommended, and may be required by NEC or
codes when batteries are remotely located. The battery disconnect switch
may be supplied as an accessory, and should be installed between the battery
and
UPS.
12. the conductors used for DC input from the battery cabinet(s) to the UPS are
those provided by the UPS manufacturer, and the UPS and battery cabinet are
manufactured by the same supplier, then is acceptable if they do not meet the
noted minimum conductor sizes.
NO:
2 o f
L