PowerTech MB3908, Инструкция по эксплуатации

Страница: 13 / 24

10
MEMORY FUNCTION / RESET:
SWITCHING BETWEEN MODES:
After connection to mains, the charger automatically returns to the last
charge mode used. If the charger stays on “STANDBY” press the mode key.
NOTE:
Long press 3sec. the MODE selection button at no battery connected
status. The device switches between charging modes in the following order:
Standby
>
MODE 6 SMPS 13.6V
>
then repeats the cycle.
Press the MODE selection button the appropriate number of times.
The device switches between charging modes in the following order for
12V battery:
Standby
>
MODE 2
>
MODE 2 & 3 and
>
then
repeats the cycle.
The device switches between charging modes in the following order for 24V
battery:
Standby
>
MODE 1
>
MODE 1 & 3 and
>
then
repeats the cycle.
Long press 3 sec. the MODE selection button the appropriate number of
times. The device switches between charging modes in the following order:
Standby
>
MODE 4 ADV. AGM 12V
>
MODE 9 LITHIUM 12.8V
>
MODE 7 RECOVER 12V
>
then repeats the cycle.
NOTE:
• MODE 9 LITHIUM 12.8V : If voltage of the battery is out of 11.6-13.8V,
Mode 9 is not available, will go to MODE 7 RECOVER 12V directly.
• MODE 7 RECOVER 12V : Repair & Recover and charging the deeply
discharged or sulfated (desulfation) 12V batteries.
• If you press the selector button, charging mode automatically switches
over to the next mode and begins operation in that mode.