PowerTec Digimax, Инструкция по установке и эксплуатации

Страница: 22 / 46

Page 14 © copyright 1992-1996 by Powertec Industrial Motors
P O W E R T E C
DIGIMAX ®
POWERTEC Industrial Corporation
Rock Hill, South Carolina, USA 29732
SERIAL NO:
D A T E :
P A R A M E T E R D E S C R I P T I O N R A N G E D E F A U L T V A L U E
1 Maximum Motor Speed
0 to 65535
1750
2 Display High EGU 0 to 99999 1750
3 Decimal Places 0 to 4 0
4 Base Ratio 0 to 79999 1 . O O O O
5 Feedback PPR 0 to 9999 120
6 Acceleration Time 0 to 99999 10
7 Deceleration Time 0 to 99999 10
8 Master/Slave 0 to 2 0
9 Preset Speed 0 to 99999 200
10 Jump UP Change 0 to 99999 10
11 Jump Down Change 0 to 99999 10
12 Up to Speed Tolerance 0 to 255 10
13 J u m p / M O P 0 to 1 0
14 Float/Freeze 0 to 1 0
15 Display Sample Rate 1 to 255 1
16 Setup During Run 0 to 1 1
17 Unit ID 1 to 255 1
18 Baud Rate
3, 6, 12, 24, 48 or 96
96
19 Local/Remote/Keylock 0 to 2 0
20 ** A to D Trim SETPOINT 0 to 99999 0
21 Operator Password 0 to 99999 0
** Parameter #20 function was used as Speed/Ratio setpoint. Change was
implemented in Software version 93166.
Table I: Parameter table for the DIGIMAX DIGIMAX DIGIMAX DIGIMAX DIGIMAX
®
. Default values are the values used for basic testing. Values used in a particular
application may be entered in the VALUE column.