PowerTec Digimax, Инструкция по установке и эксплуатации

Страница: 20 / 46

Page 12 © copyright 1992-1996 by Powertec Industrial Motors
REM/LCL
Press the ALT key followed by the "9" key to toggle between the Remote and
Local modes of the DIGIMAX DIGIMAX DIGIMAX DIGIMAX DIGIMAX
®
. In Local mode (REMOTE LED indicator in the display is off)
all keypad functions are active. In Remote mode only the REM/LCL function and the COM/
ACT key will operate. If parameter #19 is set to "2" (KEYLOCK), you must press the ALT key,
an access code, the UP key and the ENT key in sequence before the DIGIMAX DIGIMAX DIGIMAX DIGIMAX DIGIMAX
®
will switch
back to the Local mode from the KEYLOCK mode.
ON
The ON function (the "UP" key) will only work for the AUXOUT and the PRESET
functions. It is not necessary to press the ALT key between the PRESET key and the ON
key or after the AUXOUT number key before the ON key.
OFF
The OFF function (the "UP" key) will only work for the AUXOUT and the PRESET
functions. It is not necessary to press the ALT key between the PRESET key and the OFF
key or after the AUXOUT number key before the ON key.
RESETTING PARAMETERS TO FACTORY DEFAULTS
The parameters may be reset to the factory default values by the following key
sequence (the DIGIMAX DIGIMAX DIGIMAX DIGIMAX DIGIMAX
®
must be in the stopped mode):
[ALT] [CMD] - The display will blank out.
[7] [9] [1] [3] [5] - A dash ("-") will appear for each number entered.
[ENT] - A "y" will appear in the display.
[UP] - the parameters should be reset to the defaults.