Powermatic 1200HD, Инструкция по эксплуатации и перечень запасных частей

Страница: 10 / 32

10
4. IMPORTANT: The hub area of variable speed
pulleys should be oiled with a light lubricant
such as SAE 10W or automatic transmission
oil every 90 days.
5. Apply Lubriplate to quill pinion every 90 days.
6. Occasional dressing of belt with spray can
type belt dressing or parafin wax will promote
longer belt life and quieter operation.
NOTE: Use extreme care when performing
this operation and keep hands clear of pinch
points. When using parafin bar, do this only
by turning the sheaves by hand. DO NOT
apply with motor running.
7. When equipped with mechanical power feed
unit, periodically coat the gears with a good
open gear lubricant.
DRILL PRESS OPERATIONS
Familiarize yourself with all operating controls
before attempting use of this machine.
CONTROLS (see Figure 5)
1. The spindle (A) in this machine has a No. 3
Morse Taper.
2.
A depth stop rod (B) is provided to control hole
depth and to prevent drilling through material into
table surfaces.
3.
A quill lock (C) is located on the left side of the
head and is used to hold quill at any position.
4.
The turret handle (D) is used to lower the
spindle and quill a total depth of 6"
5.
A safety collar (E) is provided to prevent head
from falling when locks are released.
6.
Starting switch (F) is mounted on the front of
drill press head within easy reach of the operator.
7.
A speed selection chart (G) is located on the
FIGURE 5
front of the head. This chart is to provide assis-
tance in determining proper drill speed.
8.
On all 1200HD models, a knob (I) is used to
change speed.
9.
On production table models, binder (J) locks
the table to the column and handle (H) is used to
raise and lower the table.
10. The model 1200HD is provided with an AC-
inverter (K) which is pre-programmed from the
factory and requires no changing or adjustment.
OPERATING TIPS
1. Determine drill size, inspect for sharpness,
insert and lock securely in chuck or Morse taper.
2.
Arrange at this point to protect table surface
from drill breakthrough. A piece of scrap material
under the workpiece will prevent marring table
surface and eliminate splintering at breakthrough
point. Lock table securely to prevent movement.
3.
Prevent the work from being torn from
operator's hand, by always securing the workpiece,
jig, fixture, or holding device to table by clamping or
blocking on the table. DO NOT use the column as a
stop. Clamp all light workpieces, jigs, fixtures, or
holding devices to the table to prevent them from
being picked up as the quill returns.
4.
Select the proper RPM for the tool being used,
the material being machined, the operations to be
performed, and other conditions as indicated. (See
Tables 1A, 1B, 2, and 3 on pages 25 thru 28 for
recommendations.) If drill press is the step pulley
type, raise door and set drive belt in proper ration
position. If the machine is a variable speed model,
turn machine on the turn control cam to proper
speed. (NEVER attempt speed adjustment of
variable speed machines unless machine is run-
ning.) Turn machine off.