9
Reset lockscrew (A), make sure point of screw mates
to flat on the housing journal.
REPLACING SPINDLES ON QUILL
ASSEMBLY
To change the quill assembly for any reason, proceed
as follows:
1.
Hold quill return spring housing (B) in left hand
(Figure 3) and loosen lockscrew (A). Let spring
unwind slowly, by allowing cam to turn in hand.
2.
Loosen setscrew (C) and remove nut (D) on
bottom of depth stop rod. Unscrew and remove
depth stop.
3.
Hold quill assembly and remove the turret pinion
shaft (E). Entire quill assembly will slide out of
head.
To change spindles, follow the above steps, then
(Figure 4):
1.
Loosen setscrew in collar (J). To reach this
screw, insert a 5/32" hex head wrench.
2.
With a hard rubber mallet or block of wood, tap
spline end of spindle. The spindle, with bearing
(K), will come out of quill.
3.
Use an arbor press to remove bearing (K).
4.
To replace spindle, reverse above procedure.
5.
When replacing collar (J), remove all end play
from spindle.
6.
When replacing quill in head casting, rotate
spindle, if necessary, to engage spline in pulley
driver.
7.
Remove lock ring (F) and cover plate (G)
(Figure 3) from spring housing and make
certain tongue on return spring is properly
inserted in slotted end of pinion shaft. Replace
cover and adjust spring tension as instructed
under heading "QUILL RETURN SPRING
ADJUSTMENT."
LUBRICATIONS
All ball bearings in your Powermatic drill press are
sealed for life, requiring no lubrication. Points requir-
ing lubrication are:
1.
Internal spline drive assembly. Keep this area
well lubricated with a good grade non-hardening
grease, such as Fiske Company "Lubriplate."
Insert grease in the hole at the top of spindle
pulley spline driver. Lube twice yearly.
2.
A light film of oil applied to the quill and column
will reduce wear, prevent rust and assure ease
of operation.
3.
Quill return spring should receive oil (SAE 20)
once yearly. Remove cover plate and apply
oil with squirt can or small brush.
FIGURE 3
Quill Removal
FIGURE 4
Spindle Assembly
Содержание 1200HD
