Charging Spot Installation
6.
Magnetic Module Subassembly – Sub-surface Installation
1.
Separate magnetic module subassembly (F) from electronics module
subassembly (G) by pressing the quick-release connector lever and pulling gently.
2.
Place the centering spacing ring subassembly (I) on top of the coil encasing on
the magnetic module subassembly
3.
Pointing the quick-release connector in the general intended orientation of the
electronics module, insert the coil encasing all the way into the cavity, and hold it
in place. It is important to verify the encasing sits flat and tight against the
surface layer.