Charging Spot Installation
4.
Add 3-4 dots of silicone on inner bottom lip of the cap (D). This silicone will
keep the cap tightly secured to the surface.
Figure 6
5.
Pass the heat sink mount through the hole from the top of the surface, and press
the surface-mounted cap onto the hole, so the cap shoulders sit snug against the
surface. If the cover fits unevenly, remove and identify the problem. File any burrs
as needed.
Figure 7
6.
Using one hand, firmly press the cap against the surface to prevent it from rising,
and the artwork from rotating. Reach from underneath the surface, and using
your other hand, tighten the 3 latches evenly until the cap and the coil encasing
sit securely in place.