Charging Spot Installation
5.
Magnetic Module Subassembly - Surface Mounted
1.
Separate magnetic module sub-assembly (F) from electronics module sub-
assembly (G) by pressing the quick release connector lever and pulling gently.
Figure 4
2.
Hold the magnetic module such that the quick-release connector points toward
the desired installation orientation of the electronics module and housing.
3.
Place the cap (D) on the coil encasing in accordance with the desired direction of
the artwork printed on the cap (facing the intended user), then turn the cap a ¼
of a turn, such that it cannot be separated by pulling it away from the magnetic
encasing. Try to pull it out to verify it is properly connected.
Figure 5
Quick- release
connector