Charging Spot Installation
Figure 8
7.
Verify the cap sits tight against the surface and that it cannot be turned or pulled
out.
8.
Slide the electronics module sub-assembly (G) into place to connect with the
magnetic module sub-assembly (F) until clicked in place.
Figure 9
9.
Accurately align and square the electronic module subassembly according to the
desired orientation of the CS for wiring. Secure the heat sink mount to the
surface using 3 x #6 3/8” screws (A). Secure electronic module sub-assembly (G)
using 2 x #6 1” screws (B).
Figure 10