Powerline PL2100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 20

stock, press the clamp/blade switch and the blade switch (located in the right switch panel) at the same time. Hold the
switches down until the blade has cut through the stock, then release the switches. The blade and clamp will automatical-
ly return to the up position.
6.3 Cutting Procedure for Model PL2100
1. While observing the analog scale, move the back gauge to the required cutting position. Turn the back gauge lock knob
clockwise to lock the back gauge in position.(See Section 5.0)
2. Slide the paper stock (maximum height 2 7/8") under the blade and clamp. Position
the stock against the back gauge and against either the left or right paper guide. Lower
the front safety cover.
NOTE: The front safety cover must be in the lowered position before the blade or
clamp will operate.
3. Rotate the clamp handle assembly clockwise to lower the clamp on to the paper
stock. Firmly tighten the clamp to secure the stock.
4. Press the reset switch located in the left switch panel. If all safety conditions are met,
the amber colored ready light will illuminate indicating that the machine is ready to cut.
5. Press the blade switches (located in each switch panel) at the same time and hold them down until the blade cuts through
the stock. Release the blade switches to allow the blade to return to the up position.
6. Turn the clamp handle assembly counter-clockwise to release the stock.
7.0 Maintenance
WARNING! This machine contains a powered cutting knife which can cause serious or even fatal injury.
Never connect power to the machine until you are ready to set up and operate the electric cutter. To
prevent injury, never place hands or arms under the cutting blade, do not operate the machine with any
covers removed or safety features disabled, and cut only paper materials. Before attempting any main-
tenance procedure, be sure power is disconnected and locked out.
7.1 Blade Removal
WARNING! The cutting blade is extremely sharp. Serious bodily harm can result from mishandling.
NOTE: To prevent dulling the knife, do not let the knife edge contact any surface except the cutting surface or blade
carrier.
1. Activate machine power. Lower the cutting blade as if you are cutting paper. Turn off
the On/Off toggle switch when the blade contacts the cutting stick. Turn the key
switch to the “OFF” position (key vertical). Raise the front safety cover.
NOTE: The front safety cover must be in the lowered position before the blade or
clamp will operate.
2. Remove the far right blade retaining screw.
CAUTION: Do not operate the blade or clamp with the blade holder tools
attached to the blade. Extensive equipment damage can occur.
3. Turn the On/Off toggle switch and key switch to the “ON” position so that the blade and clamp will return to the up
position. Turn the key switch to the OFF position (key vertical). Remove the two center blade retaining screws. Install
and securely tighten the blade holder tools.
WARNING! When you loosen the blade holder tools, the blade will be free to fall from the carrier. Make
sure you have a firm grip on the blade holder tools.
4. Raise the front safety cover. Loosen the remaining blade retaining screws. Loosen the blade holder tools and carefully
lower the blade from the blade carrier.
PowerLine Operating Instructions
6
12
Short Cut
When cutting carbonless paper,
install the false clamp to help pre-
vent bruising and marking.
1