Powerhorse M1577110E, Руководство пользователя

Страница: 18 / 62

18
result in catastrophic high pressure release of fluid as
well as hose whipping.
Avoid sharp objects. Keep hose away from sharp
objects. Bursting hoses may cause injury.
No load bearing . Do not use the pump to support other
items of equipment that impose unacceptable loads on
the pump. Do not attempt to use this machine as a prop.
Lock trigger safety latch when not spraying . Spray
gun is equipped with a built-in trigger safety latch to
guard against accidental trigger release. Rotate safety
latch to the locked position when not spraying.
Leaving unattended . Always turn off the pressure
washer and relieve system pressure before leaving the
sprayer unattended.
Prompt Emergency Response
Seek medical aid for suspected injection injury . If
injured by high-pressure fluid, no matter how small the
wound is, see a doctor at once. A typical injection injury
may be a small puncture wound that does not look
serious. However, severe infection or reaction can
result if proper medical treatment is not administered
immediately by a doctor who is familiar with injection
injuries.
Seek medical aid for suspected carbon monoxide
poisoning
. The running engine gives off carbon
monoxide, a poisonous gas that can kill you. If you start
to feel sick, dizzy, or weak while using the pressure
washer, shut off the engine and get to fresh air RIGHT
AWAY. See a doctor. You may have carbon monoxide
poisoning.
Put on Personal Protective Gear
WARNING: Personal Protective Gear
Use personal protective gear to prevent:
- Eye and skin injection injury from high pressure spray
- Eye injury from flying debris
1. Wear waterproof gloves, safety glasses with side and
top protection, face protection, and protective
clothing when operating the machine. If spraying
pressure washer specific chemicals, wear a
respirator mask to avoid inhalation of vapors if
directed on the chemical label.
2. Wear non-slip, protective footwear. Use of pressure
washer can create puddles and slippery surfaces.
Wear footwear capable of maintaining a good grip on
wet surfaces.
Preparing for Operation
Make sure that any regular maintenance has been
performed as prescribed in
“Maintenance & Repair”
section.
Check/Add Oil to Pump
CAUTION
Never run the pump without sufficient lubrication!
1. Turn off engine, allow it to cool and disconnect
the spark plug wire.
2. Twist dipstick cap until the arrow on the cap
lines up with the arrow on the breather plug
tube. Remove the dipstick from the breather
plug tube. Then remove the breather plug tube
from the pump.
3. Wipe the dipstick off with a clean dry cloth.
Insert the dipstick cap into the pump housing
and remove it. The oil level should be at least to
the lower “L” notch on the dipstick, but not
above the upper “H” notch. Add above
recommended oil as needed.