Powerhorse M1577110E, Руководство пользователя

Страница: 14 / 62

14
POSITIVE CABLE
Fig
047
20
Fig04
721
Battery Installation (15771120 only)
10. Route cable as shown. Note: Ignition switch and
starter removed for clarity.
A.) Note: a battery is not required for pressure
washer operation. If a battery is not installed,
care must be taken to prevent the Positive
Battery Cable from contacting the steel
pressure washer frame.
B.) Install a 12-volt battery with a minimum of 10
amp hour rating and max dimensions of 6-1/8” x
3-1/2 x 4-7/16”.

The battery is to be supplied by the customer.

(2) 1/4” nuts and (2) 1/4” bolts to be supplied by
customer.
C.) Follow the steps below for connecting and
disconnecting the battery:
WARNING: Battery Hazards
Batteries are hazardous because they contain
caustic acid, can emit explosive gases, and can
cause electric shock. Caution must be exercised
when making connections to a battery to avoid
shock and contact with the acid, and to prevent
any sparking that could lead to an explosion.
ALWAYS follow the general battery safety rules
and instructions.
General Battery Safety Rules

ALWAYS use eye protection and protective
clothing when handling batteries.

NEVER smoke or work near sparks or other
sources of ignition.

NEVER touch both battery terminals at the same
time with your hand or any non-insulated tools.
If battery acid contacts skin or clothing, flush
immediately with water and neutralize with baking
soda.
11. Connecting the Battery
Always connect the cables in the following
sequence to avoid possible shock:
a.
Connect the red cable to the positive (+)
terminal of the battery.
b. Then connect the black cable to the
negative (-) terminal of the battery.
Disconnecting the Battery
Always disconnect cables in the following sequence
to avoid possible shock.
a. Remove the battery from the battery bracket.
b. First, disconnect the black cable from the
negative (-) terminal of the battery.
c. Next, disconnect the red cable from the
positive (+) terminal of the battery.
d. Reinstall the battery strap.
Red
Black
Bolt (x2)
Nut (x2)
*Nuts and bolts
not supplied.