WATERBLASTER TERMINOLOGY
Following are common terms associated with the use of waterblasters:
PSI:
Pounds per square inch – common unit measure used for water pressure, air
pressure, hydraulic pressure and pounds of force.
LPM:
Liters per minute – common unit measure used for flow rate of water.
.
Bypass Mode:
In bypass mode, high pressure pump recirculates water because
spray gun trigger is not squeezed.
Thermal Relief Valve:
When in Bypass Mode, this valve releases a jet of water to
prevent water temperatures from reaching harmful levels that damage the pump. Once
the water has cooled, the thermal relief valve will reset itself. Do not allow pump to run
without spraying (in Bypass Mode) for more than 2 minutes.
ASSEMBLY / ATTACHMENTS
This Waterblaster requires some assembly and will be ready for use after servicing
with manufacturer approved oil and petrol.
If you have any problems with the
assembly of your waterblaster, please call the waterblaster helpline at
1-888-278-8092
. If calling for assistance, please have the model, revision, and seri-
al number from the data tag available.
WATERBLASTER
Unit is heavy.
Do not attempt to lift and remove
the Waterblaster unit from the carton.
1. Using a box cutter, open carton completely by cutting the four corners allowing
the sides to lay flat. Leave Waterblaster on the carton.
2. Remove all items except the Waterblaster from the box and inspect for com-
pleteness (See Functional Description).
3. Carefully tip the Waterblaster forward and place on its front side and
proceed to assemble the unit using the provided tools.
4. Insert the shaft through the holes in the bottom frame tubing as shown.
5. Assemble the wheels to the shaft (using the bushings, washers and cotter
pins). To secure the Wheels to the shaft, insert the Cotter Pins inside the small
holes in the shaft and bend back the end of the Cotter Pins using a pair of pliers
(not provided).
6. Assemble the Legs to the bottom frame tubing (using the nuts and bolts) as
shown. Tighten all mounting hardware.
7. After completion of wheel/leg assembly, carefully place the Waterblaster on
its wheels and legs.
15
Содержание EGS0252
Страница 40: ...38 ...
