Powerbuilt EGS0252, Инструкция по эксплуатации

Страница: 15 / 40

DO NOT use acids, toxic or corrosive chemicals, poisons, insecticides, flamma-
ble solvents or bleach with Waterblaster. Use of these chemicals can result in
damage to equipment or serious injury or death.
DO NOT direct spray toward electrical outlets, switches or products
connected to electrical service. Failure to observe this warning can
result in electrocution resulting in severe electrical shock or burns
and possibly resulting in death.
NEVER run the pressure pump without the water supply connected and turned
on. Non-repairable damage to the pump will occur.
RISK OF FALLING
Waterblaster can create puddles of slippery solutions that can
become hazardous.
Ensure you stand on a stable surface while operating Waterblaster. Initial kick-
back from engaging spray wand can cause you to lose your balance and fall
resulting in minor to severe injuries.
Use extreme caution if you must operate Waterblaster from a ladder or
scaffolding. Kickback from spray wand can result in a loss of balance and result
in a fall that could cause serious injuries.
When cleaning with the waterblaster, ensure there are adequate slopes for drainage
so solutions don’t create puddles around unit that could result in slipping and falling.
Firmly hold spray wand with both hands when using high pressure spray avoid-
ing injury should spray wand kick back.
The Waterblaster must be run with the rubber feet resting on a flat and
stable horizontal surface.
The Waterblaster must be used in a clean and well-ventilated area. Keep Waterblaster a
minimum of 1.5 m of clearance on all sides including overhead.
DO NOT place Waterblaster in an area:
• Where there is evidence of oil or gas leaks.
• Where flammable gas vapors or materials may be present.
• Where extremely dirty air or water could be drawn into the Waterblaster.
13