Power Towers nano SP, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 24

BATTERY CHARGING
The battery charger is located under the checkerplate cover. A.
First switch off Nano SP and isolate power by depressing the battery isolator switch at
base of machine.
The charging lead (usually fitted with a yellow 110V plug) is on the exterior of the
machine base (this lead can be fitted with 230V plug if required) B. The battery charger
is fully voltage sensitive, so there is no voltage selection to do when connecting to
different voltages.
Plug into available power supply and ensure the green light is illuminated. C. The
charger LED indicator lights can be viewed through a window in the chassis from the
rear of the machine, to the left hand side of the base of the post. The Amber LED has
three modes:
1. Rapid flash, which indicates maximum charge rate.
2. Slow pulse, indicating slower charging.
3. Continuous illumination indicating the battery is fully charged
D.
4. Additionally the battery charge indicator is the left hand LED on
basket joystick.
D1.
Note: The amber light may not switch on immediately, and may take
up to 10 minutes to do so.
The battery charger can be connected to the mains supply at any time or left for
extended periods. The machine can be operated when the charger is connected,
although this is not recommended. All mains supply should be protected with
a suitable RCD.
Note: The charger is fitted with a 10A automotive spade fuse (red). If the fuse has failed,
the indicator lights will still operate. The fuse may have failed if the battery is heavily
discharged and the motor is run when the charger is switched on. In such an event, the
fuse is simple to replace.
MAINTENANCE PROCEDURES
C
A
B
D
9
D1