Power Stroke PSi2000B, Руководство оператора

Страница: 19 / 48

Page 15 — English
OPERATION
MAINTENANCE
Normal maintenance, replacement or repair of emission
control devices and systems may be performed by any
qualified repair establishment or individual with original
or equivalent parts. Warranty and recall repairs must be
performed by an authorized service center; please contact
customer service for assistance.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from
spark plug. Allow 30 minutes of cool down time before
performing any maintenance. Failure to follow these
instructions can result in serious personal injury or
property damage.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
GENERAL MAINTENANCE
Keep the generator in a clean and dry environment where it
is not exposed to dust, dirt, moisture, or corrosive vapors.
Do not allow the cooling air slots in the generator to become
clogged with foreign material such as leaves, etc.
Do not use a garden hose to clean the generator. Water
entering the fuel system or other internal parts of the unit can
cause problems that will decrease the life of the generator.
To clean the unit:

Use a soft bristle brush and/or vacuum cleaner to loosen
and remove dirt and debris.

Connect the battery charging cable assembly to the
12 V DC receptacle.

Start the generator.
NOTE: The AC receptacles can be used while the DC
receptacle is in use.

The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
NOTE:
Only use battery charging cable assembly to
charge vented wet lead acid batteries.

When batteries become fully charged, disconnect the bat-
tery charging cable assembly from the battery. Disconnect
the negative (black) wire first, then the positive (red) wire,
being careful not to short across the terminals. Always
abide by the safety warnings provided with the battery.
NOTE:
Most batteries will be completely charged after
30 to 120 minutes. However, it is highly recommended
that you refer to your battery manufacturer’s instructions
for specific charge times.

Unplug battery charging cable assembly and store for
later use.
MOVING THE GENERATOR
See Figure 10.

Turn off the generator.

Allow 30 minutes of “cool down” time before storing the
machine.

Pull the retractable handle out.

Facing the back of the generator, grasp the folding handle
firmly with one hand.

Lift the generator toward you until it balances on the
wheels.

Turn around and pull the unit along behind you to the
desired location.

Lower the generator until it sits securely on a flat surface.
HIGH ALTITUDE OPERATION
Your engine is configured for operation below 2000 feet
altitude at the factory. Your engine must be reconfigured for
operation above 2000 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade per-
formance, and cause irreversible damage. Engines configured
for high altitude operation cannot be operated in standard
altitude conditions. A qualified service center should ensure
that your engine is properly configured for your location.