Power Stroke PS141912, Руководство оператора

Страница: 13 / 40

Page 9 — English
ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
TOOLS NEEDED
See Figure 4.
The following tool (not included or drawn to scale) is needed
for assembly:

Phillips Screwdriver
INSTALLING THE WHEELS
See Figure 5.


Locate the axles, hitch pins, washers and wheels.


Slide the axle through the hole in the center of the wheel.


Slide a washer onto the axle before inserting into the
frame.

Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
  Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
  Repeat with the second wheel.
INSTALLING HANDLE AND TRIGGER
HANDLE AND NOZZLE STORAGE BRACKET
See Figure 6 - 7.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Installing handle:

Align the handle with the holes in the frame.

Push and hold the button on the handle.
Installing trigger handle holder and nozzle storage
bracket:


Align trigger handle holder with holes in handle, as shown.


Install screws and tighten securely.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 8.


Push the end of the spray wand into the trigger handle
and rotate clockwise to secure.

Pull on the spray wand to be certain it is properly secured.

Place the assembled spray wand in the trigger handle
storage bracket.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 9.

 Remove the high pressure hose from the hose storage
strap.


Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.

Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 10.

Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
(See Page 13) for more information about using the high
pressure hose.

Align the collar on the hose to the threaded outlet on the
pump.

Insert the high pressure hose collar onto the threaded
outlet.

Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.