Power smart PS76168A, Инструкция по эксплуатации

Страница: 10 / 17

10
ASSEMBLY INSTRUCTION
WARNING:
Do not use this product if any parts on the packing list are already assembled to your product
when you unpack it. Parts on this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may have been improperly assembled
could result in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not recommended for use with
this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
INSTALLATION OF THE VACUUM CLEANER
WARNING:
To reduce the risk of injury, turn unit off, disconnect it from power source and
remove the battery before installing and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
Installing the casters

Turn the container upside down.

Insert the four caster feet into the holes on the container. Using firm and
steady pressure, press the caster downward until it will go no further (See fig.2).
Fitting the filter
To be effective in minimizing dust re-circulation the filters must be installed correctly and in good
condition.
Note: Never operate without a filter in place. A clean filter is the most important factor in the operation
and efficiency of any vacuum.

Turn machine off and remove the battery pack.

Install the HEPA filter onto the power head (See fig.3).

Then insert the cloth filter into the vacuum container, aligning the edge of the cloth filter with the rim
of the container (See fig.4).

Replace power head onto the container and secure latches (See fig.5).
Fig.2
Fig.3
Fig.4
Fig.5