Power smart PS76168A, Инструкция по эксплуатации

Страница: 11 / 17

11
Fitting the suction hose and tube
Connect the suction hose to the container by screwing the rotatable plastic end piece of the suction
hose into the hose connection securely.
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the
instructions in the battery charger section.
To install the battery pack
To connect the battery, insert/slide battery into battery port . Make sure the battery pack is fully seated.
To remove the battery pack
Press the battery release button ,slide the battery pack backward, and then pull or lift the battery out of
the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
•
Read, understand, and follow the instructions.
OPERATING INSTRUCTION
WARNING:
To reduce the risk of injury, turn unit off, disconnect it from power source and
remove the battery before installing and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
SWITCHING ON/OFF
WARNING: Do not switch on the vacuum cleaner until
it has been completely assembled.

To switch the unit on, set the On/Off switch to position "I".

To switch the unit off, set the On/Off switch to position "O".
Off
On
Fig.6