Power-flo PFG3022, Инструкция по установке, обслуживанию и запасным частям

Страница: 4 / 20

Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com
4
Specifi cations
MODEL HP Hz Volts/Ph RPM
Full Load
Amps
Locked
Rotor Amps
NEMA Start
Code
Cord
Type Cord
Size
Cord
O.D.
PFG3022*
›
3 60 230/1 3450 26 90 H SOW 10/4 .75
PFG3062 3 60 208/3 3450 17 65 J SOW 10/4 .75
PFG3032 3 60 230/3 3450 14.5 62 K SOW 10/4 .75
PFG3042 3 60 460/3 3450 7.2 31 K SOW 10/4 .75
PFG5022* 5 60 230/1 3450 39 136 H SOW 10/4 .75
PFG5062 5 60 208/3 3450 25 122 K SOW 10/4 .75
PFG5032 5 60 240/3 3450 21.9 120 L SOW 10/4 .75
PFG5042 5 60 460/3 3450 11 60 L SOW 10/4 .75
PFG7532 7.5 60 230/3 3450 22.3 136 J SOW 10/4 .75
PFG7542 7.5 60 460/3 3450 11.2 68 J SOW 10/4 .75
Moisture & Temperature sensor cable for all other models is 18/5 SOW. 0.47 inches O.D. See page 17 for Relay kits.
(*) IMPORTANT! - These pumps require a control panel with start, run capacitors and relay. Capacitor kits which include Start &
Run capacitors and Start Relay, are available if a Power-Flo control panel is not used, see page 17.
PFG 3, 5 & 7.5HP Submersible Grinder Pumps
Recommended Breaker & Heater Sizes
MODEL HP Hz Volts/Ph Breaker Size
Heater
Size **
Voltage Relay Start Capacitor Run Capacitor
PFG3022*
›
3 60 230/1 80 AMP K-70 MARS 64 189-227 mfd-220 volt 40 mfd - 370 volt
PFG3062 3 60 208/3 40 AMP K-56 N/R N/R N/R
PFG3032 3 60 230/3 30 AMP K-54 N/R N/R N/R
PFG3042 3 60 460/3 15 AMP K-41 N/R N/R N/R
PFG5022* 5 60 230/1 80 AMP K-70 MARS 64 189-227 mfd-220 volt 40 mfd - 370 volt
PFG5062 5 60 208/3 50 AMP K-63 N/R N/R N/R
PFG5032 5 60 240/3 50 AMP K-62 N/R N/R N/R
PFG5042 5 60 480/3 20 AMP K-50 N/R N/R N/R
PFG7532 7.5 60 230/3 50 AMP K-67 N/R N/R N/R
PFG7542 7.5 60 460/3 30 AMP K-54 N/R N/R N/R
N/R = Not Required
Winding resistance ± 5% at terminal block. Rated operation at ± 10% voltage at motor.
(**) Recommended heater sizes may very depending on pump station requirements.
(
›
) This data is for the PFG3022, from Sept 2010 and newer. For units prior to Sept 2010 use to following: FLA - 21.7, LRA - 75,
NEMA code - G, Breaker Size - 50amp, Heaters K-64, Relay MARS 65, Start Cap. 257mfd - 220volts, Run Cap. 20mfd-370volts.