Power Fist 8726325, Руководство пользователя

Страница: 7 / 28

V4.0 Portable Lumber Mill 8726325
Visit www.princessauto.com for more information 7
13. Loosen the coupling nuts on the u-clamps enough to slide the adjustment
posts through post clamps. The thrust post is on the left and the nose
guard post is on the right. The engraved ruler should be visible on the
inner side of each post.
14. Tighten the carriage bolts.
COMPLETING ASSEMBLY
15. Insert the handle bar (#21) through the upright square bracket. The handle
bar must be flush with the outer surface of the end bracket (Fig. 13). If it
sticks out, push it in until it is flush. The bar can extend past the other end
bracket. Insert an end cap (#16) into each end of the handle bar (Fig. 14).
16. Insert a pan head screw (#1) into the square bracket on each side and
secure with an M5 hex head lock nut (#3).
17. Tighten all M8 nuts
and coupling nuts
with a wrench. Do
not overtighten, as
some nuts must
remain loosen for later adjustments (Fig. 15).
LUMBER MILL ADJUSTMENT
The lumber mill is attached to a chainsaw with a maximum bar length of 24 in.
The lumber mill must be adjusted to properly fit the bar length.
1. Loosen the M8 nuts on the right-side end bracket. Loosen the M5 Pan
Screw (#1) on the square clamp. Slide the bracket to the end of the
thickness rails (#10). Hand-tighten the M8 nuts to keep it in place.
2. Loosen the bolts on both post ends to widen the clamp’s gap.
3. Insert the chainsaw bar through the thrust side post gap, then through to the
nose guard end clamp. The cutting edge of the chainsaw faces away from you.
4. Position the thrust end clamp so it only touches the bar and not the engine
housing. Wrench-tighten the clamp to secure the bar.
5. Loosen the M8 nuts on the other post’s end bracket. Reposition the bracket
and post until the clamps will only touch the bar and not the chain. Wrench
tighten the M8 and M5 nuts on the bracket.
Fig. 13 Fig. 14
Fig. 15