Power Fist 8726325, Руководство пользователя

Страница: 6 / 28

8726325 Portable Lumber Mill V4.0
6 For technical questions call 1-800-665-8685
ASSEMBLE THE ADJUSTABLE POSTS
8. Slide an M8 flat washer (#7) onto each of two M8x75 hex bolts (#11).
Insert the bolts through the bolt holes in the thrust end adjustment post
(#12), then into the thrust end clamping bracket (#13). Make sure the side
of the adjustment post with measurements on it is facing away from you
when assembling. Tighten
the M8 nuts (#6) on the
bottom of the clamping
bracket. Leave a gap loose
enough for the chainsaw’s
bar (Fig. 5, 6 and 7).
9. Slide an M8 flat washer (#7) onto each of two remaining M8x75 hex bolts
(#11). Insert the bolts through the bolt holes in the other adjustable post
(#22). Slide the bolts through
the ends of the nose guard
(#14), then through the
clamping bracket (#20).
Tighten the hex bolts (#11)
into the M8 nuts on the
bracket’s bottom. Leave a gap
loose enough for the chainsaw
bar (Fig. 8, 9 and 10).
10. Insert an end cap (#18) onto the end of each post.
11. Place the curved surface of the post clamp (#5) against the inner bend of
the u-clamp (#4). Insert
the u-clamp ends
through the bracket’s
bolt holes from the outer
side (Fig. 11). Slide a flat
washer (#5) over each
end of the u-clamp, then
secure with an M8x25 coupling nut (Fig. 12).
12. Repeat Step 11 on the right end bracket. The u-clamp is inserted through
the inner side of the end bracket and secured on the outer side.
Fig. 8
Fig. 9
Fig. 10
Fig. 5
Fig. 6
Fig. 7
Fig. 11
Fig. 12