Power Fist 8726325, Руководство пользователя

Страница: 9 / 28

V4.0 Portable Lumber Mill 8726325
Visit www.princessauto.com for more information 9
2 Use a tape measure for a more accurate measurement. All three measurements
should come to the same result when properly set up.
a. Measure from the bar to the bottom of the end bracket (#8). Subtract
the thickness rail height from this measurement. Repeat the
measurement on the other end bracket.
b. Measure from the bar to the bottom of the on/off guide bar (#19).
c. Measure the difference in height between the bar and the chain’s tooth
with a precision caliper. Reduce the prior measurements by this amount.
3. Start the chainsaw.
4. Hold the chainsaw by the handle. Rest your arm on the lumber mill’s
handle bar while gripping the handle when operating the assembly.
5. Place the leading thickness rail onto the ladder or level lumber surface.
Angle the thrust side so the curved clamp ends guides the chainsaw into
the lumber. Straighten the lumber mill so it evenly cuts.
6. Push the lumber mill assembly forward at a slow even pace to prevent
jamming while cutting.
7. Insert a wedge into both sides of the cut every few feet to prevent it from
pinching or binding the chain bar.
8. Continue the cut until the lumber’s end is reached and follow through until
the chainsaw bar is free of the lumber.
9. Shut off the chainsaw.
10. Readjust the lumber mill’s thickness after the first cut to that of the desired
board thickness.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.